Problem with Alarm Clifford 420.4x

Hi everyone! I recently bought a clifford alarm (model 420.4x), is installed and all wiring is properly connected; the problem is that when the alarm is activated and open a door alarm is not activated no flashing lights , no siren sounds. I don´t know if I have to make some programming to activate that function. I read the manuals (phyton 424, clifford 420.4x, viper 4204) , 2 alarm technicians checked me and everyone says that the alarm is well connected but no response when the alarm is activated.

Is the unit connected to a door trigger, what vehicle, make model, year?

sorry forgot the car information, Kia Rio 2016, and yes the unit is connected to a door trigger

Green wire from H2?

The green wire from h2/6 is connected and the violet h2/12. It is connected and tested

Check voltage between any input fuse and your grounding point.

If you have a 420.4x, it is a remote start/keyless entry unit. No alarm features. Was a siren included with the kit?When all else fails, Read the Instructions

Support the12volt.com Make a Donation

No the siren wasn't included with the kit. Then is there no alarm features?

Remote start/keyless entry only. No alarm. Nice units. Good range, reliable. My wife has had the Viper brand in her Corolla for over 6 years. Never had a problem.When all else fails, Read the Instructions

Support the12volt.com Make a Donation

itself has very good specifications, I bought it thinking that alarm worked well, but it only works me like central locking because where the installed the technical know nothing about remote start. Well, thanks you (howie ll & smokeman1), That solves the problem of alarm function.