I just installed a Avital 4105 and Dball2 in a 2011 Toyota Sienna (G-Key). I have the door locks working, but no the the remote start. When I press the button for remote start the lights on the remote blink, but neither the Avital or Dball2 have any lights on them and nothing appears to change in the car. Once I lock the car the Avital has the red LED slow blinking which I think is normal. I have flashed the Dball2 with the Sienna firmware and am using D2D mode. I have it in D2D mode for tach. I think I am missing a safety or bypass. Here is what I have:
AVITAL CONNECTIONS:
Heavy Gauge relay, white 6-pin connector;
1 - Red connected to constant 12V
2 - pink/white connected to yellow second ignition
3 - red connected to another constant 12V
4 - orange - not connected
5 - Purple - Connected to Red(stater1)
6 - Pink - Connected to Black ignition 1
Primary Harness, white 9 pin;
1 - light GREEN/ black (-) 200ma Factory alarm disarm output - not connected.
2 - GREEN / WHITE (-) 200ma Factory alarm rearm output - not connected.
3 - Yellow (+) ignition out (to alarm) - Not connected
4 - WHITE/ blue (-) activation input - not connected
5 - orange (-) 500mA GWL. antigrind - not connected
6 - Brown (-) 200mA horn output - not Connected
7 - RED / white (-) 200mA Trunk release output - not connected
8 - Black Chasis ground - Connected to Ground
9 - White (+/-) light flash output - not connected
Remote start harness, white 5 pin connector
1 - BLACK/ white (-) Parking brake input - not connected
2- Violet/white Tach input - not connected.
3 - Brown (+) brake shutdown input - not connected
4 - Gray (-) hood pin input - Connected to supplied hood pin.
5 - Blue/White (-) 200mA rear defogger - not connected
Satellite Harness - Not connected
Door Lock harness - Not connected
D2D Harness - connected to Dball2
DBALL2 CONNECTIONS
Blue harness
tan/black - connected to HS Can high
Tan - Connected to HS Can Low
Yellow - Connected to SIL interr connector side
Orange / YELLOW - connected to SIL interr vehicle side
Red Connector
Yellow/Black connected to SIL
ORANGE / black connected to RDA
black harness
Pink connected to Ignition 1 input
D2D connector - connected to Avital D2D port
Any advice on what to try next. I have reflashed and double checked all wiring, was not sure if something that is not connected needed to be connected.
Thanks