2004 dodge ram remote start

Home / the12volt's Install Bay / Car Security and Convenience / 2004 dodge ram remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

truck guy

Member - Posts: 1

Joined: December 02, 2004

Location: United States

Posted: December 02, 2004 at 8:47 PM / IP Logged

i am looking for a schematic to install a valet model 561T remote start on a 2004 dodge ram any help will be greatly appreciated

daniel2002p

Silver - Posts: 524

Joined: October 10, 2003

Location: United States

Posted: December 02, 2004 at 11:25 PM / IP Logged

Dodge

Ram Pickup

2004-2004

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	Yellow	IGNITION SWITCH HARNESS*
Ignition #1:	Pink/White	IGNITION SWITCH HARNESS
Ignition #2:	Pink/Lt.Green	IGNITION SWITCH HARNESS
Ignition #3:	Dk. Blue	IGNITION SWITCH HARNESS
Accessory:	Pink / YELLOW (16 awg) & Pink / YELLOW (14 awg)	IGNITION SWITCH HARNESS
Brake Light:	WHITE/ Tan (+)	Above the brake pedal switch
Tach Signal:	DK. blue/Gray	Found at Power Control Module (PCM)* *
Parking Lights:	WHITE/ Lt. Green (-)	Found at the Headlight Switch* * *
Headlights:
Diesel Glow Plug:
Clutch Bypass Wire:
Notes:	* Many Of These Vehicles Are Equipped With A Transponder (Even If The Key Is Black). Use Universal Alarm Bypass Module Part Numner 2x402 Where X Can Be Any Number. PCM found on the passenger side of the firewall. * The parking lights are negative trigger through a 2.7K ohm resistor. **** A negative trigger using 420 Ohm resistor will disarm the alarm. A negative trigger using a 2k Ohm resistor will arm the alarm.

Dodge

Ram Pickup

2004-2004

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	Red (+)	IGNITION SWITCH HARNESS
OEM Alarm Disarm:	PURPLE / Lt. Blue (-)	Drivers Kick Panel, Resistance based* * * *
Dome Lights/Superv:	See Note Below*****	See Note Below*****
OEM Horn:	Dk.GREEN/ Purple (-)	Steering Column
Power Lock:	PURPLE / Green (-)	See Note Below******
Power Unlock:	Single wire (-)	See Note Below******
Trunk Release:
Alarm Input Wire:	See Note Below*****	See Note Below*****
Notes:	*** Separate Triggers For Each Door. The door pin wires are located in the drivers kick panel for the both left doors and The door trigger wires for the passengers door are found in the passengers kick panel. The Driver's Door Trigger Is Purple (-). The Left Rear Door Trigger Is PURPLE / Orange(-). The Passenger Front Door Trigger Is PURPLE / White (-) And the Passenger Rear Door Trigger Is Purple / YELLOW (-). Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. **** Single Wire Door Lock System See Note #211. The door lock wire is located in the drivers kick panel. Lock is a Negative Trigger Through a 800 Ohm resistor. Unlock is Negative Trigger through a 340 ohm resistor.

2005 Toyota Corolla S

1.8L VVT-i I-4

Always double check your wires with a DMM!!!

Do Not Use A Test Light!!!

MECP Certified Installer!

Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

bdl666

Silver - Posts: 330

Joined: December 31, 2002

Location: United States

Posted: December 03, 2004 at 12:56 PM / IP Logged

You might have to use a different value resistor than that listed above for the parking lights. I did a truck like this about a month ago and the wiring diagram I used was from www.bulldogsecuity.com and it had a 249ohm resistor listed ( I used a 250ohm resistor and it worked ).

forbidden

Platinum - Posts: 5,352

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

Joined: November 01, 2003

Location: Alberta, Canada

Posted: December 03, 2004 at 1:47 PM / IP Logged

I just had a tech brief sent to me one these trucks from B&B Electonics. If this is a diesel pickup then there could be issues. I'll snoop around for this buried document.

Top Secret, I can tell you but then my wife will kill me.

extreme1

Silver - Posts: 1,070

Joined: February 12, 2003

Location: Canada

Posted: December 03, 2004 at 2:39 PM / IP Logged

document is in regards to manual diesels and tach wire.

Apparently some installers have found a way to use an injector wire, how I don't know.

I always grab the dark blue/gray wire at the PCM.

Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2004 dodge ram remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.