need wiring diagram 2002 focus sdt

could anyone pass it on to me, i need to instal remote star security system

here you go.   xs

FOCUS   2000 -2003 

 KEY  T-HARNESS  IMMOBILIZER   FD KEY-3    N/A    FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM, Requires 791 and Extra Ignition Key   PART   COLOR  LOCATION  DIAGRAM  12 VOLT CONSTANT   RED (+)    IGNITION SWITCH HARNESS      STARTER  GRAY/BLACK (+)   IGNITION SWITCH HARNESS      STARTER 2  N/A       IGNITION 1  GREEN/ YELLOW (+)  IGNITION SWITCH HARNESS    IGNITION 2  N/A        IGNITION 3  N/A         ACCESSORY /HEATER BLOWER 1  YELLOW (+)   IGNITION SWITCH HARNESS      ACCESSORY /HEATER BLOWER 2  N/A         KEYSENSE  N/A         PARKING LIGHTS ( - )  N/A         PARKING LIGHTS ( + )  ORANGE / YELLOW (+)   @ HEADLIGHT SWITCH      POWER LOCK  BLACK/ RED (TYPE B)   IN DRIVERS KICK PANEL      POWER UNLOCK  BLACK / YELLOW (TYPE B)   IN DRIVERS KICK PANEL      LOCK MOTOR WIRE  YELLOW/BLACK (+)   IN DRIVERS KICK PANEL      DOOR TRIGGER  BLACK / YELLOW (-) and BLACK/ BLUE (-) use Both, See NOTE *1   LOW IN DRIVERS KICK PANEL, See NOTE *1   14301_FOCUS_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf   DOMELIGHT SUPERVISION  USE DOOR TRIGGER         TRUNK RELEASE  BLACK / YELLOW (-)   @ TRUNK RELEASE SWITCH or KEYLESS ENTRY MODULE, See NOTE *3      SLIDING POWER DOOR  N/A         HORN  BLACK/ BLUE (-)   @ STEERING COLUMN HARNESS      TACH  BLACK/ GREEN   @ IGNITON COIL      WAIT TO START LIGHT  N/A         BRAKE  LIGHT GREEN/ RED (+)   @ SWITCH ABOVE BRAKE PEDAL See NOTE *2      FACTORY ALARM DISARM   N/A         ANTI-THEFT  FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM   TRANSPONDER @ IGNITION SWITCH TUMBLER     NOTES  NOTE *1 This vehicle has (2) door trigger wires, when connecting to an ALARM SYSTEM, use both wires and DIODE ISOLATE, to connect, See DIAGRAM

NOTE *2 The IGNITION SWITCH MUST be turned on before the Brake wire will test properly.

NOTE *3 The FACTORY KEYLESS ENTRY Module (if so equipped) is located behind and to the right of the GLOVE BOX

expandable sound

south of boston

Manual reservation system probably refers to a sequence of events that must occur before the system will allow a remote start sequence to initiate. Systems designed for manual transmissions operate in this manner. Some require that when you are ready to put the car into 'ready' mode, you set the parking brake, keep foot off of brake pedal, push remote start button, exit vehicle and close door...this tells the system that it is ok to remote start when requested. Most of these systems will also deactivate the mode if the door is opened, or unlocked prior to remote starting. These are safety features.