2003 caravan remote start

Home / the12volt's Install Bay / Car Security and Convenience / 2003 caravan remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

bronco5000

Member - Posts: 5

Joined: July 10, 2005

Location: Canada

Posted: October 26, 2006 at 11:46 PM / IP Logged

installing a 3300 prostart in my brothers caravan with factory security. it will crank over but will not start. I need a wiring diagram for that make of van. I think I am missing a ignition wire. security is not shutting it down, it cranks for the 8 sec then trys over again. any help would be great.

ps also need to know how to power up the heater motor

any info is good info

Mike M2

Platinum - Posts: 2,652

Joined: June 29, 2005

Location: United States

Posted: October 27, 2006 at 6:25 AM / IP Logged

1 2volts	lt. blue/red (10A)	+	ignition harness
Notes: This wire is rated at 10 amps only. If installing any system with high current outputs, go to the battery for 12v.
Starter	yellow	+	ignition harness
Second Starter	PURPLE / brown	-	ignition harness
Notes: The second starter wire is negative trigger thru a 180 ohm resistor. MUST use relay. Refer to directfax document #1083 for wiring information.
Ignition	pink/white	+	ignition harness
Second Ignition	N/A
Third Ignition	N/A
Accessory	not required for remote start

Did you hook up the second starter wire? this will make it not start....

Mike M2

Tech Manager

CS Dealer Services

kgerry

Platinum - Posts: 3,455

This member consistently provides reliable information

Joined: February 07, 2004

Location: Saskatchewan, Canada

Posted: October 27, 2006 at 9:15 AM / IP Logged

also, what bypass module did you use? what color is the head of the key?

Kevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

sparkie

Platinum - Posts: 2,061

Joined: November 06, 2003

Location: Canada

Posted: October 27, 2006 at 2:47 PM / IP Logged

It sounds like you didn't hook up the relay to pulse the viloet/brown wire to ground through a 180 ohm resistor during crank. This is why it won't start and why the climate controls aren't working.

sparky

bronco5000

Member - Posts: 5

Joined: July 10, 2005

Location: Canada

Posted: October 28, 2006 at 12:44 AM / IP Logged

did not hook up the neg wire to starter(did not know about it lol)it must be a feed to the body control module

I did not hook up the accessories yet, which wire is it?

thanks

any info is good info

green6767

Copper - Posts: 209

Joined: October 28, 2005

Location: United States

Posted: October 28, 2006 at 6:57 AM / IP Logged

Accessory runs with ignition in those vehicles, so you dont need to hook it up. You only need to hook up 12V, ignition (pink/white), starter (yellow), and second starter (negative with 180 ohm resistor through a relay. If you didn't hook that up, the van is just gonna sit and crank. Also, which color is the head of the key for the van? If its grey, you need a bypass for the transponder type key. If its black, you wont need to bypass the key.

Shaun, we are the same height, that is neat!

12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2003 caravan remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.