1992 Chrysler Concorde remote start

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 1992 Chrysler Concorde remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

moparfreak77

Member - Posts: 14

Joined: February 20, 2003

Location: Canada

Posted: January 04, 2004 at 5:29 PM / IP Logged

I am hooking up a car starter on this Concorde and would like info on the colour of wires I need to hook it up. I think all I need is the colour of a wire that has power in the start and crank positions. thanks

Bnluis

Silver - Posts: 578

Joined: December 24, 2002

Location: New York, United States

Posted: January 04, 2004 at 6:08 PM / IP Logged

CHRYSLER CONCORDE 93-95
WIRE	COLORS	LOCATION
12 VOLTS CONSTANT	PNK/BLK & RED	IGN HARNESS
IGNITION 1	D BLU	IGN HARNESS
IGNITION 2	RED / WHT	IGN HARNESS
IGNITION 3
ACCESSORY /HEATER BLOWER 1	BLK/ORG	IGN HARNESS
ACCESSORY /HEATER BLOWER 2
STARTER	YEL	IGN HARNESS
PARKING LIGHTS	BLK/YEL(+)	HEADLIGHT SWITCH
DOMELIGHT	YEL(-)	12 PIN CONN IN DRV KICK
PWR DOOR LOCK	ORG/WHT	12 PIN L BLU CONN
PWR DOOR UNLOCK	PNK/VIO	ON BACK OF FUSE BLOCK (TYPE A)
TRUNK RELEASE	BLK/WHT(+)	AT RELEASE SWITCH
TACH SENSOR	GRY, RED / YEL	@ COIL PACK ON ENG
BRAKE	WHT/TAN(+)	AT SWITCH ON BRAKE PEDAL BRACKET
HORN	BLK/RED(-)	STEER COLM
FACTORY DISARM	L GRN/ORG(-)	BLK 16 PIN CONN IN DRV KICK PANEL

1992 Chrysler Concorde remote start -- posted image.

Luis

Sound Waves

Is up to the installer to test all wires with a DMM whenever possible.

moparfreak77

Member - Posts: 14

Joined: February 20, 2003

Location: Canada

Posted: January 04, 2004 at 7:31 PM / IP Logged

Very awesome!, thanks a lot. But I just got in from the garage! I'll work on it tomorrow maybe. thanks again.

moparfreak77

Member - Posts: 14

Joined: February 20, 2003

Location: Canada

Posted: January 04, 2004 at 7:36 PM / IP Logged

Question though...when you say "GRY, RED / YEL" for the tach sensor...that means 2 wires? thanks

Bnluis

Silver - Posts: 578

Joined: December 24, 2002

Location: New York, United States

Posted: January 04, 2004 at 7:50 PM / IP Logged

use only one use the gray one

TACHOMETER|gray | |ignition coil pack

Luis

Sound Waves

Is up to the installer to test all wires with a DMM whenever possible.

moparfreak77

Member - Posts: 14

Joined: February 20, 2003

Location: Canada

Posted: January 05, 2004 at 6:25 PM / IP Logged

Hey Bnluis...how about the wires i need for a '95 Jeep Cherokee? and what do i have to do to wire the door locks into the auto starter (it has that option). I do have the factory keyless entry remote.

Bnluis

Silver - Posts: 578

Joined: December 24, 2002

Location: New York, United States

Posted: January 07, 2004 at 11:11 PM / IP Logged

I don't recommend using the factory remote, On those year models the distance sucks, but if you starter comes with remotes that operate door locks you can always connect them. Some of those car are equipped with factory alarms, you will require some relays.

Jeep

Grand Cherokee

1993-1995

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	YELLOW/DARK BLUE	IGNITION SWITCH HARNESS
Ignition #1:	DARK BLUE/GRAY	IGNITION SWITCH HARNESS
Ignition #2:	ORANGE / BLACK	IGNITION SWITCH HARNESS (HEAT-A/C)
Ignition #3:	N/A
Accessory:	BLACK/ WHITE	IGNIITON SWITCH HARNESS (RADIO/WIPER)
Brake Light:	WHITE/ TAN (+)	SWITCH ON BRAKE PEDAL BRACKET
Tach Signal:	GRAY/WHT OR GRAY/BLACK	AT COIL OR PCM *
Parking Lights:	DARK BLUE/RED (+)	HEADLIGHT SWITCH OR AT FUSE BOX
Headlights:	TAN/BLACK (+)	HEADLIGHT SWITCH OR BEAM SELECT SW.
OEM Alarm Disarm:	VIOLET / YELLOW	(-) DRIVER KICK PANEL
OEM Alarm Arm:	N/A
Diesel Glow Plug:
Clutch Bypass Wire:
Notes:	* Powertrain Control Module (PCM) Located In Passenger Rear Corner Of Engine Compartment Near A/C Receiver/Dryer. Tach Wire At Pin #19, GRAY/L BLUE At Pin #43 Can Also Be Used For Tach.

Jeep

Grand Cherokee

1993-1995

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	RED / WHITE FUSED AT #	AMP AND PINK/BLACK FUSED AT # AMP
Starter Kill:	YELLOW/DARK BLUE	IGNITION SWITCH HARNESS
Ignition +12 Volts:	DARK BLUE/GRAY	IGNITION SWITCH HARNESS
Dome Lights/Superv:	YELLOW (-)	DRIVER KICK PANEL OR COURTESY LIGHT
OEM Horn:	GRAY/ORANGE (-)	STEERING COLUMN HARNESS OR AT RELAY
Power Lock:	ORANGE / VIOLET	DRIVER'S KICK PANEL **
Power Unlock:	PINK/VIOLET	DRIVER'S KICK PANEL **
Trunk Release:	ORANGE / BROWN (+)	LIFT GLASS RELEASE (AT SWITCH)
Alarm Input Wire:	YELLOW (-)	DRIVER KICK PANEL OR COURTESY LIGHT
Notes:	** See Note #202 - Positive Pulse Door Lock Diagram.

Luis

Sound Waves

Is up to the installer to test all wires with a DMM whenever possible.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1992 Chrysler Concorde remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.