1997 Mazda Millenia Alarm, Remote Start, Keyless Entry Wiring
Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
( 1997 Mazda Millenia Alarm Information )
| 1997 Mazda Millenia Alarm, Remote Start, Keyless Entry Wiring Information |
| Constant 12V+ | Green (2) |
Ignition Switch Harness |
| Starter |
Black/Yellow |
Ignition Switch Harness |
| Ignition |
Black/White |
Ignition Switch Harness |
| Ignition 2 |
Black/Red |
Ignition Switch Harness |
| Accessory |
Blue |
Ignition Switch Harness |
| Tach |
Yellow |
Distributor or Green/Blue in 16 Pin Connector left of Steering Column |
| Neutral Safety Wire |
Black/Red (-) |
Starter Relay Engine Computer Fuse Driver's Side |
| Brake Switch |
Green/Black |
Brake Switch |
| Trunk Release |
Brown/White (+) |
Switch |
| Trunk Pin |
Red (-) |
16 Pin Connector Rear of Fuse Panel Position 15 |
| Parking Lights |
Green |
Steering Column |
| Head Lamp |
White/Purple (-) |
Light Switch |
| Factory Disarm |
Light Green/Red (-) |
Driver's Kick Panel, use 1000 Ohm Resistor |
| Door Trigger |
Light Green (-) |
Harness behind Fuse Panel |
| Door Lock |
Black/White (-) |
Back of Fuse Block at CPU |
| Door Unlock |
Black/White (-) |
1K Resistor to Lock, (-)Unlock |
| Horn Wire |
Green/Red (-) |
Switch Changes Red/White |
| Windows Up |
LF=Green, RF=Green/White, LR=Blue/White, RR=Green/Yellow |
| Windows Down |
LF=Red/Blue, RF=Red/White, LR=Yellow/White, RR=White/Red |
|
|
Follow the12volt.com
Tuesday, April 23, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
