1999 Mitsubishi Diamante Alarm, Remote Start, Keyless Entry Wiring

Home / the12volt's Install Bay / Vehicle Wiring / View all Mitsubishi Vehicles / 1999 Mitsubishi Diamante

Vehicle Search	Manufacturer
Select Vehicle Manufacturer
If you do not find the vehicle information you're looking for here, please post your request here. We will NOT respond to any requests by email.

• Cruise Control Information

• View all Mitsubishi Vehicles

Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
( 1999 Mitsubishi Diamante Alarm Information )

1999 Mitsubishi Diamante Alarm, Remote Start, Keyless Entry Wiring Information
Constant 12V+	Red	Ignition Switch Harness
Starter	Black/Red	Ignition Switch Harness
Ignition	Black/White	Ignition Switch Harness
Ignition 2	Blue/Red	Ignition Switch Harness
Accessory	Blue/Red (+)	Ignition Switch Harness
Tach	White/Green	Coil
Brake Switch	Green/White	Brake Switch
Trunk Release	Red/Yellow	Driver's Kick Panel Blue 22 Pin Connector Position 14
Trunk Pin	Green	Junction Block left Side of Dash
Parking Lights	Green/White (+)	Driver's Kick Panel
Factory Disarm	Red/Green (-)	Passenger's Kick Panel
Door Trigger	Green/Red	Courtesy Light under Dash
Door Lock	Blue (-)	ECM Module, Driver's Kick Panel
Door Unlock	Red/Green (-)
Horn Wire	Green/Silver Dots	(-)Ignition Harness
Windows Up	LF=Green/Black, RF=Green/Black, LR=Green/Black, RR=Green/Black
Windows Down	LF=Red/Blue, RF=Red/Blue, LR=Red/Blue, LR=Red/Blue

• Cruise Control Information

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.