1998 Ford Crown Victoria Alarm, Remote Start, Keyless Entry Wiring
Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
( 1998 Ford Crown Victoria Alarm Information )
1998 Ford Crown Victoria Alarm, Remote Start, Keyless Entry Wiring Information |
Constant 12V+ | Yellow or Light Green |
Ignition Switch Harness |
Starter |
White/Pink |
Ignition Switch Harness |
Ignition |
Brown/Pink |
Ignition Switch Harness |
Ignition 2 |
Pink/Black |
Ignition Switch Harness (Air Bag ) |
Ignition 3 |
Black/Light Green |
Ignition Switch Harness |
Accessory |
Gray/Yellow (2) |
Same Wires Ignition Harness (Heat/AC) |
Tach |
White/Pink |
PCM DR Rear Engine near Master Cylinder, 1 Cylinder Setting |
Neutral Safety Wire |
Not Grounding |
OEM Switch opens Starter Circuit |
Brake Switch |
Light Green |
Brake Switch or 16 Pin Connector Driver's Kick |
Trunk Release |
Purple/Yellow (+) |
3 Pin Connector Driver's Kick Panel |
Trunk Pin |
Black/Pink (+) |
Trunk LID Switch Center of Trunk |
Parking Lights |
Brown (+) |
Light Switch or Driver's Kick Panel Black Connector |
Head Lamp |
Red/Yellow (+) |
Light Switch |
Factory Disarm |
Green/Purple (-) |
Driver's Door Boot |
Door Trigger |
Black/Light Blue (+) |
Light under Dash |
Door Lock |
Pink/Yellow |
W/Keyless Positive Trigger Driver's Boot |
Door Unlock |
Pink/Light Green |
W/o Keyless Entry Reverse Polarity |
Horn Wire |
Dark Blue (-) |
Steering Column |
Windows Up |
LF=White/Black, RF=White/Yellow, LR=Gray/Orange, RR=Red/Black |
Windows Down |
LF=Tan/Black, RF=Tan/Light Blue, LR=Yellow/Blue, RR=Yellow/Black |
|
|
Follow the12volt.com
Sunday, December 8, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.