the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

1998 Pontiac Montana Cruise Control Wiring

Vehicle Search Manufacturer
Select Vehicle Manufacturer
If you do not find the vehicle information you're looking for here, please post your request here. We will NOT respond to any requests by email.

Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
(
1998 Pontiac Montana Cruise Control Information )

1998 Pontiac Montana Cruise Control Wiring Information
Constant 12V+ Red (2)  Ignition Harness One is 60 Amp and 40 Amp or Use Hot Side of Brake
Switched 12V+ Pink  Ignition Switch Harness 
Ground Use Chassis  Near Cruise Control Module 
Hot Side of Brake n/a  Brake Switch 
Cold Side of Brake White  Brake Switch 
Tach White  PCM left Side of Engine in Air Filter 
VSS Wire Green  Driver's Front Quarter Blue 80 Pin Connector Position 13 
Pulses Per Mile 4000 PPM 
Notes: Vehicles with Manual Transmission require Clutch Switch. Some vehicles may require a speed signal generator and/or other parts/adapters not listed above. Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.


  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, October 15, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer