spacer spacer spacer spacer

1997 Toyota Camry Cruise Control Wiring

Vehicle Search Manufacturer
Select Vehicle Manufacturer
If you do not find the vehicle information you're looking for here, please post your request here. We will NOT respond to any requests by email.

Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
1997 Toyota Camry Cruise Control Information )

1997 Toyota Camry Cruise Control Wiring Information
Constant 12V+ White or White/Red  Ignition Harness or Use Hot Side of Brake
Switched 12V+ Black/Red  Ignition Switch Harness 
Ground Use Chassis  Near Cruise Control Module 
Hot Side of Brake n/a  White Connector bottom right of Fuse Panel 
Cold Side of Brake Green/White  White Connector bottom right of Fuse Panel 
Tach Black/Orange (AC)  ECM Behind Glove Compartment 
VSS Wire Purple/Yellow  Passenger's Dash 22 Pin Connector of ECM 9 TOP 
Pulses Per Mile 4000 PPM 
Notes: Vehicles with Manual Transmission require Clutch Switch. Some vehicles may require a speed signal generator and/or other parts/adapters not listed above. Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.

Follow Follow on Facebook
Thursday, September 21, 2023 • Copyright © 1999-2023, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo spacer spacer spacer
Top spacer spacer