Sony 16 Pin Diagram

Home / the12volt's Install Bay / Car Audio / Sony 16 Pin Diagram (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

pv13

Copper - Posts: 158

Joined: April 11, 2005

Location: United States

Posted: May 16, 2009 at 7:13 PM / IP Logged

I have a Sony CDX-C5050X CD player but with no harness. This unit is 9 years old, and I am only using it as a shop radio, so I don't want to put anymore money into it by purchasing a harness.

Does anyone know what the pin diagram might be for this 16 pin harness? Or is there a way to test which wire is which?

Thanks

i am an idiot

Platinum - Posts: 13,723

This member consistently provides reliable information

Joined: September 21, 2006

Location: Louisiana, United States

Posted: May 16, 2009 at 7:40 PM / IP Logged

I can help you figure out what is what. Is there a fuse on the back of the unit? Do you have a digital multimeter? With the meter set to the diode test function, this is the symbol that should be on that setting. Sony 16 Pin Diagram -- posted image. Attach the black lead of the meter to the chassis of the radio. Now touch the red lead to each of the pins on the plug. One pin will beep at you and read very near 0.000. Label that pin as ground. There will be 8 pins that have the same exact reading. Those are speaker wires. We will get to that later. If there is a fuse, you should be able to get a meter lead on the element of the fuse, there is a hole on each side of the fuse that allows access to the element. One lead on the fuse other lead to the remaining unidentified pins, one of them will read very near 0.000 label that one as constant voltage. You should have only 2 or 3 unidentified pins now. Draw a picture of what you found or take a pic and label what you have found, I can tell you where the switched wire is located.

pv13

Copper - Posts: 158

Joined: April 11, 2005

Location: United States

Posted: May 18, 2009 at 12:23 AM / IP Logged

I believe I found the constant 12 volt, ground, and speaker wires, but there is still 6 wires that I haven't identified. 4 of the pins didn't fluctuate from the OL on my multimeter, while the other 2 gave me some readings.

Thanks

i am an idiot

Platinum - Posts: 13,723

Joined: September 21, 2006

Location: Louisiana, United States

Posted: May 18, 2009 at 1:37 AM / IP Logged

7 or 15 is switched. probably 7. It really does not matter from here. The only wires left are Switched, remote, power antenna, and possibly a mute wire (not likely on a Sony). The good thing about that is any of those wires will NOT be damaged by applying 12 volts to them. Solder your wires on ground and constant, connect them to the appropriate battery terminals. Now touch another power wire to 7 and turn the radio on. If it comes on solder that wire there. If not try it on 15, one of them is switched. Once you get that, we need to find out if speaker wires are 1,2 3.4 or 1,9 2,10. In order to figure this out, balance to the left and fade to the front. wire up a speaker and touch the wires to 1,2 3,4 9,10 11,12 Then from 1,9 2,10 3,11 4,12. Several of these combinations should make sound. One combination will be considerably louder. Make note of the louder pair. Balance right, and do it again with the remaining wires. Label the louder pair. Fade rear and do it again. Label that pair. If it is 1,9 2,10 etc. 9 10 11 and 12 are your positive wires. If it is 1,2 3,4 9,10 11,12 2,4,10,and 12 are your positive wires.

It is hard to identify the switched wire with a meter. It is simply a voltage sensing wire. it pulls no current through that wire. If it did pull current it would make the meter react.

pv13

Copper - Posts: 158

Joined: April 11, 2005

Location: United States

Posted: May 18, 2009 at 4:52 PM / IP Logged

The switched 12v was number 7. And the speakers were as follows:

Front Left: 1,9

Front Right: 4,12

Rear Left: 2,10

Rear Right: 3, 11

Thanks for your help.

i am an idiot

Platinum - Posts: 13,723

Joined: September 21, 2006

Location: Louisiana, United States

Posted: May 18, 2009 at 5:58 PM / IP Logged

Glad you got it working.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Sony 16 Pin Diagram

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.