the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

valet 712t 2005 taurus


Post ReplyPost New Topic
< Prev Topic Next Topic >
danboy 
Member - Posts: 4
Member spacespace
Joined: November 12, 2006
Location: United States
Posted: January 02, 2008 at 11:22 PM / IP Logged  
I am installing the 712t on a 2005 taurus without oem keyless entry.
This car has neg input door locks. I am a little fuzzy on the 712 interanl relay wiring. I would ground the violet and violet/black #87. Thease two wires are joined together at a fuse. Would I use the blue/black for unlock and the GREEN/ black for lock? I also have the problem of the BCM going to sleep. I am not sure if the Dome lite supervisory input or output circuit will wake it up. Thanks Dan
frans-c 
Copper - Posts: 77
Copper spacespace
Joined: February 14, 2006
Location: South Africa
Posted: January 03, 2008 at 6:17 AM / IP Logged  
Here's a diagram of the Directed 451M door lock relay. It's basically the same layout as the Valet 712T (which I also have installed).
valet 712t 2005 taurus - Last Post -- posted image.
You'll first have to determine whether your current central locking is positively or negatively pulsed. But yes, blue/black is unlock, GREEN/ black is lock.
What's the BCM...? As the installation manual states, you'll first have to determine whether your domelight circuit is positively or negatively switched.
F R A N S
1985 Mercedes-Benz 230E
320 000 km / 199 000 miles
Full MB Service History
danboy 
Member - Posts: 4
Member spacespace
Joined: November 12, 2006
Location: United States
Posted: January 03, 2008 at 7:42 AM / IP Logged  
Thanks The BCM is Body Control Module. It is a computer box that runs all of the non drive train components. After 5 minutes the BCM shuts down to save the battery. I put one aftermarket keyless on the car and you could not make it unlock the door after it went to sleep. When you open the door the dome light circuit will make it come on again. You can reprogram the bcm to leave it on,but I can't seem to make that work.
Dan
drummin89 
Member - Posts: 4
Member spacespace
Joined: January 03, 2008
Location: Pennsylvania, United States
Posted: January 04, 2008 at 9:13 AM / IP Logged  
hey, would diagram A work with this factory setup
valet 712t 2005 taurus - Last Post -- posted image.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer