kenwood dv3100 wiring

Home / the12volt's Install Bay / Mobile Video, GPS, and Navigation / kenwood dv3100 wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

84runner

Member - Posts: 2

Joined: March 11, 2008

Location: Mississippi, United States

Posted: March 11, 2008 at 8:52 PM / IP Logged

I have a Kenwood KNA-DV3100 nav unit and when the unit was taken out of the last vehicle the "S.SENS" wire had the protection diode cut off. I am trying to install this into a 2006 Toyota Tundra and would like to know how this will affect my vehicle and if I can get a new harness and where. Thanks for all your help to a Newbie on the site.

84runner

Member - Posts: 2

Joined: March 11, 2008

Location: Mississippi, United States

Posted: March 13, 2008 at 8:25 AM / IP Logged

Well I called and talked to Kenwood support about my issue and they told me that I need a 1 AMP Signal Diode to replace the diode that was cut off. so if anyone else has this problem then thats what you need according to Kenwoods tech support.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

kenwood dv3100 wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.