If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.
Printable version

| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com
Saturday, November 22, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Saturday, November 22, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.







This is a picture of the junction block just to the left of your brake pedal.
Notice the bottom left slot has no pins in it. The slot just above that is populated with several pins. Pin 8 is retained accessory. If you for some other reason need an ignition source that goes on and off with the key, pin 6.
The bundle of red wire that comes with the above mentioned harness has the proper connector on it already, and it will reach to the radio cavity of that vehicle.

