Micro Keyless Entry Switch Configuration

I have a Micro keyless entry system (DLR4V) I am going to install in my car. I have 2 wire actuators on each door. I have the system on my bench, wired up, and it works properly with the remote controls. I also want to wire in 2 momentary push buttons that are on my console, one for the lock, and one for the unlock. The switches are SPDT. The keyless entry system is designed to be used with a 6 pin momentary rocker switch. I want to use the 2 pushbuttons instead of the 6 pin switch. I can't figure out how to wire the 2 switches to the keyless entry to make it work with these switches. Here is the link to the wiring diagram. https://manualzz.com/doc/6413966/keyless-entry-dlr4v The White/Black and the Brown/Black are the wires I need to interface with my 2 SPDT momentary pushbuttons. Any help would be appreciated! VicMustang Vic

Doesn't look like it would work that way. The relays that you would need to trigger with your console switches are built on to the board of the Micro keyless. I think it would be better to get a dedicated Lock/Unlock switch and wire it in properly.

Yes, you are right. I need a reversing polarity set up, which I cannot do with the existing switches I have. Thanks for the help!Mustang Vic