the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

downfalls of powerful sub and weak amp


Post ReplyPost New Topic
< Prev Topic Next Topic >
iamme9182 
Member - Posts: 8
Member spacespace
Joined: September 24, 2003
Posted: September 24, 2003 at 4:43 PM / IP Logged  

I have a jensen LXA300 amp found here:

http://www.jungleblurbs.com/walmart/Jensen-2-887727.shtml

and im getting ready to put it into my car and was wondering if it would be appropriate to put this sub in

  http://www.circuitcity.com/detail.jsp?c=1&b=g&catoid=-8871&qp=0&bookmark=bookmark_17&oid=71444

or is the amp not powerful enough to push this sub?  if not what are the problems id run into?  it says it should have a 100-300w amp on there but i dont know how acurate that is.   i was also wondering if it is possible to run one sub off of the first channel and then my 2 rear speakers off of the 2nd channel?  if it is possible could someone give me a general idea of how the wiring would look for this?

thanks in advance

nedgeworth 
Silver - Posts: 264
Silver spacespace
Joined: November 03, 2002
Location: Australia
Posted: September 24, 2003 at 4:57 PM / IP Logged  
If you want to push that sub i'd be looking at a lot higher quaility amp. Because there is no way you will do that sub justice with so little power. But yeap of course it will run it. But if that is all you can afford you can always upgrade to a better sub amp later on.
wvsquirrel 
Gold - Posts: 1,237
Gold spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: July 27, 2002
Location: Florida, United States
Posted: September 25, 2003 at 11:52 AM / IP Logged  
I couldn't get the amp page to come up, but that sub is a 4ohm SVC, rated 250 RMS / 1000 Peak. You could throw up to apx. 500 watts to it and be safe. You will have a major performance issue if you use too little power, and could cause the amp to clip (where you end up pushing the amp too hard past it's limits), and you will get a very distorted signal and the amp will shut down. This can cause damage to both the amp and sub.
As long as the gains are set correctly you should be safe. But you would get better performance and sound quality with a higher power/higher quality amp like Nedgeworth said above.
Squirrel
"No more Cpt. Kirk chit chat"
If its too loud, then you're too old
Donate to the12volt.com

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer