Clifford 3.5 RSX Install ?

Home / the12volt's Install Bay / Car Security and Convenience / Clifford 3.5 RSX Install ? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

njs1stlt

Member - Posts: 5

Joined: February 15, 2003

Location: United States

Posted: March 28, 2004 at 10:13 AM / IP Logged

(Installed into a 2000 Nissan Xterra)

All went well with the install and is working with the exception of the dome light when the system is activated/deactivated. The output from the alarm is a -200 mA output, my question is can I tie that into the SMART entrance control system Room Lamp output(RED / blk), or should I use a separate relay and if so where would I tie it into? Any help is appreciated thanks in advance.

Basically when I dissarm the system my domelight no longer comes on, but it does come on when I turn the key off. Prior to the install the domelight would turn on when the factory alarm was deactivated and shut off when activated.

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: March 28, 2004 at 3:41 PM / IP Logged

what is the polarity of the output wire for that feature???

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: March 28, 2004 at 3:43 PM / IP Logged

just wire up a relay from that output and tie into the dome light wire...

Dome Light RED / BLACK (-) AT PIN SWITCH OR SECU *

SMART ENTRANCE CONTROL UNIT Is Located High In The Driver's Kick Panel.

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

njs1stlt

Member - Posts: 5

Joined: February 15, 2003

Location: United States

Posted: March 28, 2004 at 8:25 PM / IP Logged

Thanks, did it and all is well

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Clifford 3.5 RSX Install ?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.