Jeep Liberty

Home / the12volt's Install Bay / Car Security and Convenience / Jeep Liberty (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

kerrys914

Member - Posts: 9

Joined: October 01, 2004

Location: United States

Posted: October 02, 2004 at 1:32 PM / IP Logged

How do I remove the lower trim piece below the steering wheel? I am trying to access the BCM area and it is very tight. If I could remove this trim piece it would greatly help me.

I am connecting my factory disarm output to th elibberty with a 470Ohm resistor, I will connect it to the OEM wiring....CORECT?

Cheers

Kerry

karrys914@yahoo.com

Audi 2002

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: October 02, 2004 at 3:14 PM / IP Logged

OEM Alarm Disarm LT GREEN/ ORANGE (-) AT FUSE BOX***

* BCM Located Behind Driver Dash, Left Of Column

*** OEM Disarm Requires A Ground Pulse Thru A 485 Ohm Resistor

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Jeep Liberty

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.