3rd Ford pats key

Home / the12volt's Install Bay / Car Security and Convenience / 3rd Ford pats key (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

saleen49

Copper - Posts: 99

Joined: August 31, 2004

Location: United States

Posted: October 18, 2004 at 2:59 PM / IP Logged

I purchased a third S pats key blank for my 03 Taurus, now must it be ground first to program it or can it just be held near the ignition while going through the motions with the other two keys, the blank one will be used for the bypass and i was wondering if this could be done,

thanks

JWorm

Platinum - Posts: 2,208

Joined: December 11, 2002

Location: New Hampshire, United States

Posted: October 18, 2004 at 5:16 PM / IP Logged

Install the remote start and make sure it will remote start with a programmed key in the ignition.

After that....

Key 1 on until theft light goes out.

Key 2 on until theft light goes out.

Take 3rd key, hold next to ignition cylinder and remote start the car. Key should now be programmed.

Wire up module....put car back together.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

3rd Ford pats key

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.