Nitrous oxide wiring

Home / the12volt's Install Bay / Relays / Nitrous oxide wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

allkiller

Member - Posts: 1

Joined: July 12, 2005

Location: United Kingdom

Posted: July 12, 2005 at 3:39 PM / IP Logged

Please can you suggest a relay wiring for my nitrous set up, there are two solenoids that have to be switched on after first arming the system, followed by the full open throttle micro switch activation and then the momentary activate switch on the gear stick. any Ideas ??

one04fx4

Member - Posts: 8

Joined: July 15, 2005

Location: United States

Posted: July 17, 2005 at 7:49 AM / IP Logged

what year vehicle is it going on. new or old. if is old the best way i have found is to wire two switches. one on the clutch and one on the gas. if it is new they make switches for this to run off the tps switch. all you will have to do is lift the pedal a little and it will shut it off

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Nitrous oxide wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.