how to factory disarm, 03 dodge stratus

I've done some searching around and I see many trunk release setups require a diode.  Does anyone know if mine does?  Could this be my problem. 

Coupe*(for some odd reason this vehicle has two diff diagrams for body types.)       Key Sense          WHITE/ GREEN          (-)          IGNITION SWITCH HARNESS Trnk Release          BLACK/ WHITE          (REVerse polarity, aka 5-wire)          CONNECTOR C4, PIN1 @ BCM      Alarm Disarm          ORANGE          (-)          DRIVERS KICK PANEL IN THE SAME HARNESS AS THE LOCK WIRES      __________________________________________________________      Module 1          BCM - BODY CONTROL MODULE IS ATTACHED TO THE FUSE/RELAY BLOCK AT THE END OF THE DASH ON THE DRIVER SIDE                Module 2          PCM - POWERTRAIN CONTROL MODULE IS LOCATED BETWEEN THE AIR FILTER BOX AND THE POWER DISTRIBUTION BOX ON THE DRIVER SIDE OF THE ENGINE COMPARTMENT. ________________________________________ For whatever reason, disarm is not valid, try the keysense wire for disarm.Houston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).

sedan FACTORY ALARM DISARM       LIGHT GREEN/ ORANGE (+) See NOTE *4       @ BCM, Connector C4, Pin 4, See NOTE *3 link to some note __________ do not need any diode for trunk releaseHouston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).