Shock & Radar Sensor at same time?

Home / the12volt's Install Bay / Car Security and Convenience / Shock & Radar Sensor at same time? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

N1njaTurt1e

Member - Posts: 10

Joined: February 20, 2003

Posted: February 21, 2003 at 7:32 PM / IP Logged

I just got a new alarm, an UNGO ms2007, and I was wandering if it was possible to have both the shock sensor and a radar sensor installed at the same time? If so how hard would it be to accomplish this feat?

Two_Cold

Copper - Posts: 91

Joined: July 23, 2002

Location: Canada

Posted: February 21, 2003 at 8:58 PM / IP Logged

Super simple to do. Just splice them together and use a diode to isolate the trigger outputs.

I just learned that from a post by Velocity Motors.

In the past I have not used the diode with no problems. However from reading through some posts here I have discovered that the diode should be used to prevent false alarms and damage to the other spliced in device.

N1njaTurt1e

Member - Posts: 10

Joined: February 20, 2003

Posted: February 21, 2003 at 9:14 PM / IP Logged

Cool, doesnt sound too bad. Thanks for the info!!

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Shock & Radar Sensor at same time?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.