need to create a gwr relay

Home / the12volt's Install Bay / Car Security and Convenience / need to create a gwr relay (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

thefranchise

Member - Posts: 41

Joined: August 22, 2002

Location: United States

Posted: December 28, 2007 at 9:03 PM / IP Logged

Using a RS1905 on an Infiniti I35. it only has a single output trigger that is programmable to function as either a GWR (-) or as a starter kill/anti-grind. I need the anti-grind circuit as the car will slightly grind when the key is put in after a remote start. However I need a GWR to trigger my iDatalink. I think there would be a way to create a relay (prob using two relays) and utilze the (-) Disarm trigger to provide a ground to another relay and energize a relay for GWR to the bypass unit.

Help appreciated!

519civiconair

Copper - Posts: 50

Joined: October 30, 2007

Location: Ontario, Canada

Posted: December 28, 2007 at 11:38 PM / IP Logged

use Ign. to trigger a relay sending a (-) to the idatalink so 86-Ign. 85+87-(-) ground 30-iDatalink

hope this helps

F.B.S.S air ride is the only way to roll

tedmond

Gold - Posts: 4,610

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: January 06, 2007

Location: Ontario, Canada

Posted: December 29, 2007 at 12:09 AM / IP Logged

yeap you can use ignition to turn on the bypass. the only issue is, some cars, the immobilizer must be on before ignition turns on.so as civc mentioned

85 - Ground

86 - ignition

87 - ground

30 - to bypass.

the only issue with this setup is, the idatalink will always be activated when you use the key. (since ign turns on). your unit should have a dedicated ground when running and a starter kill. btw, did u you know the anti grind is suppose to be your ground when running? starter kill only works when the car is armed. i would recomend just setting your unit to do GWR and wire it up like so.

85 - GWR

86 - Ignition (+)

87 - not used

87a - starter key side

30 - starter motor side.

you loose the starter kill (unless you have dedicated outputs, diode isolate GWR and ground when armed) but the anti grind will work when remote start has been activated. and you can also connect the GWR to your idatalink.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

need to create a gwr relay

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.