01 deville dhs python 581xp +start proble

from your alarm, look for a blue or blue with white that sats GROUND WHILE RUNNING or STATUS OUTPUT. make sure that is connected to the BLUE WIRE  on the 555G

there is  a blue wire that comes off the secondary connector on the relay...  there is a blue wire that comes off of the 555g and there is a light blue wire that comes off the 456a.. the two wires off of the 555g and 456a are connected together with another wire..(i do not know what these wires are for or what they do.. ) according to the install book the light blue wire is for the door lock unlock. and the one off of the 555g is for data..

if i connect both of those to the blue data wire on the secondary connector in the relay. i still get nothing.  but lights.

I connected the yellow wire that was cut for the starter and disconnected the relay and still nothing.. the heavy gauge wires are all soldered together.

what do i check on next?

no

Ok

this is what i need  wiring schematics for  the 456a and the 555g modules.

and the wiring schematic for the 581xp

i am going to figure this out ! however i need to proper information so i can get these darts to stick to the wall.

thanks

KJW

581 XP install guide https://www.the12volt.com/installbay/downloads.asp?srch=all&term=581

i dont have the 456A manual. maybe some1 that does can share.