auto page rs 622 lcd

Home / the12volt's Install Bay / Car Security and Convenience / auto page rs 622 lcd (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

pudge211

Member - Posts: 6

Joined: March 29, 2008

Posted: March 29, 2008 at 5:09 PM / IP Logged

I Have installed a RS-622 into a 2005 Silverado using a XPRESSVIP bypass. Install went well. Unit starts vehicle and Locks/unlocks doors. The only problem is that when the key is in ignition and the vehcle is in gear the remote start unit is clicking and sending a " Vehicle running" status to the LCD remote. If you hit the brake it shuts off and then goes thruogh the start up sequence again. What wire don't I have hooked up and where do I hookit up too?? THANK YOU FOR ANY HELP.

Back to Top

brhaugen

Copper - Posts: 275

Joined: September 30, 2005

Location: North Dakota, United States

Posted: March 29, 2008 at 5:17 PM / IP Logged

You may want to double check your wiring, It almost sounds like you have the break pedal shutdown wire with the remote start input wire reversed...

Back to Top

pudge211

Member - Posts: 6

Joined: March 29, 2008

Posted: March 30, 2008 at 12:39 AM / IP Logged

No definitely not thebrakeswitch shut down. The remote start functions properly until I put it in gear. As soon as i put the vehicle in gear the key fob starts the chirps as if it was to start then chirps to let me know the vehicle is running?? If I hit the brake switch the remote start shuts down and after I let off the brake pedal will go through the same same sequence.

Back to Top

pudge211

Member - Posts: 6

Joined: March 29, 2008

Posted: March 30, 2008 at 1:49 PM / IP Logged

Looking over the install manual I see there is a pink wire for sensor bypass 20 sec. Says some vehicles may require a timed pulsed output or keysense wire. The wiring diagram for 2005 Silverado says N/A. Does this vehicle have a keysense wire and should this pink wire be hooked up to it???

Back to Top

pudge211

Member - Posts: 6

Joined: March 29, 2008

Posted: March 31, 2008 at 7:01 PM / IP Logged

Found the problem. It was in the initial programming. the pulse for the factory alarm was set to .1 (for aftermarket alarm ) and should have been set to 3

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

auto page rs 622 lcd

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.