07 chrysler 300 c

Home / the12volt's Install Bay / Car Security and Convenience / 07 chrysler 300 c (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

kondziolka

Member - Posts: 20

Joined: April 20, 2008

Location: Colorado, United States

Posted: April 20, 2008 at 4:28 PM / IP Logged

Hey everyone first let me say that this is a great site and I hope I can help out too. I'm going to be installng a alarm remote starter on a 2007 300c on sat. and was wondering if anyone has done this car before? Thanks in advance for any help.

Where ever there is a problem there is opportunity.

i am an idiot

Platinum - Posts: 13,674

This member consistently provides reliable information

Joined: September 21, 2006

Location: Louisiana, United States

Posted: April 20, 2008 at 4:52 PM / IP Logged

Battery	LIGHT BLUE/RED	(+)	IGNITION SWITCH HARNESS
Ignition 1	PINK/WHITE	(+)	IGNITION SWITCH HARNESS
Starter 1	PINK/DARK GREEN	(+)	IGNITION SWITCH HARNESS
All Door Trigger	YELLOW/WHITE	(+)	IN HARNESS IN PASSENGER SIDE WINDSHIELD PILLAR
LF Latch	VIOLET	(-)	IN HARNESS IN DRIVER KICKPANEL
RF Latch	VIOLET/WHITE	(-)	IN HARNESS IN PASSENGER KICKPANEL
LR Latch	VIOLET/GRAY	(-)	IN HARNESS IN DRIVER KICKPANEL
RR Latch	VIOLET / YELLOW	(-)	IN HARNESS IN PASSENGER KICKPANEL
Trunk Trigger	VIOLET/ORANGE	(-)	IN HARNESS IN PASSENGER KICKPANEL
Parking Lights	WHITE/ VIOLET	(+)	IN HARNESS IN PASSENGER KICKPANEL
Low Crr Pk Lights	WHITE/ BROWN	(-)	AT VEHICLE HEADLIGHT SWITCH

Starter 1 note NOT ON ALL MODELS, FOR REMOTE START INFORMATION

All Door trigger note TO AVOID DOMELIGHT DELAY USE INDIVIDUAL DOOR TRIGGERS AND DOUBLE DIODE ISOLATE EACH WIRE

Parking Light note USE A 1.6K OHM RESISTOR

Low Current parking note (-) THROUGH 1.6K OHM RESISTOR, MUST ISOLATE FROM SWITCH WITH RELAY

i am an idiot

Platinum - Posts: 13,674

Joined: September 21, 2006

Location: Louisiana, United States

Posted: April 20, 2008 at 5:02 PM / IP Logged

The above info is for the 3.5L

kondziolka

Member - Posts: 20

Joined: April 20, 2008

Location: Colorado, United States

Posted: April 20, 2008 at 5:31 PM / IP Logged

Thanks for the info. Am I still going to use doc 1084 for this install?

Where ever there is a problem there is opportunity.

i am an idiot

Platinum - Posts: 13,674

Joined: September 21, 2006

Location: Louisiana, United States

Posted: April 20, 2008 at 6:19 PM / IP Logged

Where did Doc.1084 come from, and how long have you had said document?

kondziolka

Member - Posts: 20

Joined: April 20, 2008

Location: Colorado, United States

Posted: April 21, 2008 at 12:06 PM / IP Logged

It is the the same directed tech tip that has been around for a few years pertaing to negitive second stater through resistors.

Where ever there is a problem there is opportunity.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

07 chrysler 300 c

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.