Keyless entry problems

Home / the12volt's Install Bay / Car Security and Convenience / Keyless entry problems (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

indiglo21

Member - Posts: 8

Joined: February 16, 2003

Posted: March 08, 2003 at 7:32 PM / IP Logged

I have a '98 Mitsubishi Eclipse and I cannot get the lock wires to work when hooked up to my keyless entry unit. My unit can be used with negative and positive wiring. I have hooked up my unlock wires and they are working fine. Any help would be appreciated.

Back to Top

Haku

Copper - Posts: 204

Joined: November 22, 2002

Location: United States

Posted: March 08, 2003 at 7:56 PM / IP Logged

Be more specific, they should be -pulse, which wires are you hooked too.

Hak

Siemens Autostart

Back to Top

indiglo21

Member - Posts: 8

Joined: February 16, 2003

Posted: March 08, 2003 at 8:17 PM / IP Logged

I am hooked up to the unlock wire (brown), the lock wire (BROWN / white), 12v (white), ignition (BLACK/ white), ground, and parking lights + (GREEN/ red). Everything is working fine exept when I try to lock the vechicle using the remote.

Back to Top

Haku

Copper - Posts: 204

Joined: November 22, 2002

Location: United States

Posted: March 08, 2003 at 8:21 PM / IP Logged

POWER LOCK|RED / blue |- |*1

POWER UNLOCK|BROWN / red |- |*1

*1 Located behind the glove box in a harness.

This should get you going.

Hak

Siemens Autostart

Back to Top

indiglo21

Member - Posts: 8

Joined: February 16, 2003

Posted: March 08, 2003 at 9:35 PM / IP Logged

I couldn't find them behind the glove box so I took the door panel off and tapped into the wires from there. Right as they come out of the lock module. Is this wrong??

Back to Top

Haku

Copper - Posts: 204

Joined: November 22, 2002

Location: United States

Posted: March 08, 2003 at 10:15 PM / IP Logged

I just checked the wiring diagram on the drivers switch, and It should work the way you have it. I would double check your connection inside the door, and if you have a dmm, I would double check and make sure your connected to the correct wire, and also check to see if your output from the unit shows ground when you request a door lock. If you would like, email me and i will email you back the wiring diagrams for the door locks, from Alldata.

ip3@centurytel.net

Hak

Siemens Autostart

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Keyless entry problems

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.