556hw bypass, 03 accord, 6 speed

I am about to begin my remote start install into my 2003 accord v6 6 speed. I have one question. I have a blue/white wire coming out of my bypass module that just says remote start. Does this hook into the remote start activation wire of my remote start unit? it is also a blue white wire. I am installing a DEI python 950 into the car. I had hoped by getting all DEI equipment it would be pretty simple install. Thanks Matt

That will be connected to the dark blue status wire which is in a four pin connector on the XCRS relay pack.Prepare your future. It wasn't the lack of stones that killed the stone age.

Ok Great Thanks alot! i have one more question. On the main harness (small wired one) the WHITE/ blue wire that says remote start activation input. Where does this need to be hooked to? All the book says is its set from the factory at 2 pulses. Thanks

Don't connect it anywhere. This is only used in systems where you'd use an auxiliary channel of a security system to control remote start.Prepare your future. It wasn't the lack of stones that killed the stone age.

Yeah Sure is!

Then Im sure you need a 689m for the neutral safety wire.....That remote start alone is not meant for manual transmission vehicles...

So....... what happened?