the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2005 cadillac srx rwd and avital 4000


Post ReplyPost New Topic
< Prev Topic Next Topic >
mthake 
Member - Posts: 42
Member spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 12, 2007
Location: Missouri, United States
Posted: September 21, 2008 at 2:50 PM / IP Logged  
I'm pretty sure it's a bad module, I've tried everything and nothing makes any difference. I did get the remote start to work with the key in the ignition, but it starts and dies immediately??hmm. I did not hook up the tach wire yet, so I was going to get into the RS and set it to voltage sense. follow the directions and the rs led won't even light up to get into the programming menu, WTH! any ideas?
mthake 
Member - Posts: 42
Member spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 12, 2007
Location: Missouri, United States
Posted: September 21, 2008 at 8:11 PM / IP Logged  
things have gotten better, i went in and wired up the tach wire to complete the installation part. tried to program to the tach, and once again, no light on the avital. went through the steps anyway, tested the remote start with the key in, and it works YEEHAW!!! Led must be broke on module. I still do however have the problem with the XK01 staying solid, if anyone has any helpful information on that, I would appreciate it. Even if just to confirm that the unit is bad.
chriswallace187 
Gold - Posts: 1,661
Gold spacespace
Joined: March 11, 2002
Location: Pennsylvania, United States
Posted: September 21, 2008 at 9:58 PM / IP Logged  
At this point, if you aren't going to reflash the XK01, just get a GMDL-BP.
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
mthake 
Member - Posts: 42
Member spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 12, 2007
Location: Missouri, United States
Posted: September 21, 2008 at 10:47 PM / IP Logged  
I liked the XK01 due to the window roll up feature, upon locking the doors. Will the GMDL-BP do that?
mthake 
Member - Posts: 42
Member spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 12, 2007
Location: Missouri, United States
Posted: September 21, 2008 at 11:00 PM / IP Logged  
forgot to add that I have no way to reflash the xk. I'm going to try to find a shop in the area that might have the capabilities to do so though. Thanks for all your help Chris
mthake 
Member - Posts: 42
Member spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 12, 2007
Location: Missouri, United States
Posted: September 29, 2008 at 7:43 PM / IP Logged  
Well, I finally got the module replaced, it was definately bad. works ok now, the remote start that is, but the window rollups are not working at all. when i lock the unit, it takes about 2 seconds and then the doors lock, but no action from the windows. It says on the install sheet that it takes 2 pushes of the lock button. i tried that, but it just locks then unlocks. Could this be a problem with the RS not sending 2 pulses or something? any help would be appreciated.
thanks
chriswallace187 
Gold - Posts: 1,661
Gold spacespace
Joined: March 11, 2002
Location: Pennsylvania, United States
Posted: September 30, 2008 at 12:24 PM / IP Logged  
Yeah that would do it...Avital 4000 has a remote with the same button for lock and unlock, correct?
Assuming that the tailgate unlocks like the other doors, you could use the aux. output on the "lock" input to the XK01 and press that after locking to roll up the windows.
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
mthake 
Member - Posts: 42
Member spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 12, 2007
Location: Missouri, United States
Posted: September 30, 2008 at 10:13 PM / IP Logged  
Yes, it does and I was already looking for a different RS that would have seperate lock/unlock. that is an awesome idea and I appreciate your help once again!! Does the +/- output on the trunk key make any differance?
chriswallace187 
Gold - Posts: 1,661
Gold spacespace
Joined: March 11, 2002
Location: Pennsylvania, United States
Posted: October 01, 2008 at 1:22 PM / IP Logged  
What are you talking about "+/- output on the trunk key"?
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
mthake 
Member - Posts: 42
Member spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 12, 2007
Location: Missouri, United States
Posted: October 01, 2008 at 6:35 PM / IP Logged  
sorry about that, i see how that would sound vague. I was assuming that the door locks were a negative signal to lock, but wasn't sure if the aux 2 output would be the same?
Page of 3

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, May 17, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer