dei xk01

i installed a compustar 2 wshled-s 2-way remote start on a 01 cadillac deville dhs and used the dei xk06 for the door locks and a dei xk01 for the passkey 3. the copmustar and the xk06 work fine my problem is the xk01. after hooking it up when i plug it in the led is susposed to turn on for 2 sec then go off. well the led just stays on. it has been flashed for my car and i tried to reset the xk01 with no luck.  anyone have any ideas?? thanks

also, don't let go as soon as it starts flashing... hold it for about 4 seconds and you'll hear a click from the module...then it's ready to go....Kevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

The XK01 should do everything on that car. Shouldn't need the XK06 at all. By the way, the XK06 doesn't do locks anyway. It's for transponder bypass only in newer GM cars. It's possible that maybe having the two modules in there at once is what's not letting you program the XK01. Also, where is the purple wire from the XK01 connected in the car? Should be connected to the purple databus wire in the car. You could catch the data wire almost anywhere you want (it runs all over the car, to various modules), but the easiest would be right at the OBDII diagnostic plug under the dash.

Thanks for all of the help. I just took it back to the shop that sold me the starter and modules and had them install it. So, not everything works as it should..

I meant now, everything works as it should..