the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

running wires correctly?


Post ReplyPost New Topic
< Prev Topic Next Topic >
n2ixk 
Member - Posts: 22
Member spacespace
Joined: September 04, 2008
Location: New Jersey, United States
Posted: September 17, 2008 at 6:21 AM / IP Logged  
A CB signal (ESPECIALLY one coming out of a linear amp!) is a completely different beast compared to a high current DC power cable.
I wouldn't run a transmitter output near ANYTHING else, power or signal level. In the case of poorly shielded coax cable (most of what CBers use usually is) or an even slightly high VSWR on the transmission line, you can have high signal levels on the coax shield, which will radiate right into whatever is nearby.
Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, January 27, 2023 • Copyright © 1999-2023 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer