the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

07 audi a3 remote start


Post ReplyPost New Topic
< Prev Topic Next Topic >
vince954 
Member - Posts: 5
Member spacespace
Joined: September 20, 2008
Location: Florida, United States
Posted: September 20, 2008 at 8:36 AM / IP Logged  
I am installing a Clifford 70.5x remote start system in a 2007 Audi A3,  I will be using their CAN1 can bus interface and an inmobilizer bypass but does anyone have the connections for remote start?
cutter1122 
Copper - Posts: 103
Copper spacespace
Joined: January 16, 2005
Location: Canada
Posted: September 20, 2008 at 5:35 PM / IP Logged  

12v Constant:     RED / BLUE                              +                             AT VESCM UNDER DRIVER SIDE DASH IN 8 PIN BLACK CONN.

Starter 1:            RED                                       +                             AT IGNITION HARNESS

Ignition 1:           YELLOW                                +                             AT IGNITION HARNESS

Ignition 2:           BLUE                                     +                             AT IGNITION HARNESS

Accessory 1:        GREEN                                  +                             AT IGNITION HARNESS

Brake switch:       BLACK / YELLOW                   +                            AT SWITCH

Hand Brake:         BROWM / YELLOW                 -                             AT SWITCH HARNESS

vince954 
Member - Posts: 5
Member spacespace
Joined: September 20, 2008
Location: Florida, United States
Posted: September 20, 2008 at 5:48 PM / IP Logged  

thanks, that should help...  I will have to figure out how to get into the harness as the steering columm module is mounted right below the ignition switch and there is no obvious way to see the connections betwen them...

vince954 
Member - Posts: 5
Member spacespace
Joined: September 20, 2008
Location: Florida, United States
Posted: November 04, 2008 at 8:38 AM / IP Logged  
would you happen to have the connections for lock/unlock.  I have a can interface but its not reliable for this funciton for some reason

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, April 27, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer