the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

08 toyota sequoia, remote starter


Post ReplyPost New Topic
< Prev Topic Next Topic >
bubba-b 
Member - Posts: 3
Member spacespace
Joined: September 24, 2008
Location: Ontario, Canada
Posted: September 24, 2008 at 8:45 PM / IP Logged  
 i just try to put a starter in a 08 tou sequoia and the remote start i put in will only run 8-10s then shut down,,this is w/ the key in the ign..any thoughts..thanks
Dazed and confuzalized
StealthEs 
Copper - Posts: 326
Copper spacespace
Joined: September 04, 2003
Location: New Jersey, United States
Posted: September 24, 2008 at 9:14 PM / IP Logged  
Sounds like a bad tach wire.
Cris
bubba-b 
Member - Posts: 3
Member spacespace
Joined: September 24, 2008
Location: Ontario, Canada
Posted: October 05, 2008 at 11:25 AM / IP Logged  
does anyone know lock & unlock & factory disarm on a 08 toyota seqoia
Dazed and confuzalized
StealthEs 
Copper - Posts: 326
Copper spacespace
Joined: September 04, 2003
Location: New Jersey, United States
Posted: October 06, 2008 at 12:08 PM / IP Logged  
Power Lockred-pass kick or fuse box, white 66 pin plug, pin 49
This wire will test with the passenger door power lock switch. This wire is only needed if the power locks do not function during remote start or ignition locks. All other times just use the factory alarm arm wire.
Power Unlockwhite-pass kick or fuse box, white 66 pin plug, pin 40
This wire will test with the passenger door power lock switch. This wire is only needed if the power locks do not function during remote start or ignition locks. All other times just use the factory alarm disarm wire.
Cris
StealthEs 
Copper - Posts: 326
Copper spacespace
Joined: September 04, 2003
Location: New Jersey, United States
Posted: October 06, 2008 at 12:09 PM / IP Logged  
Factory Alarm Armlt. blue to purple-driver kick or fuse box, white 66 pin plug, pin 53
Meter this wire while turning the key in the driver door key cylinder. This wire will also lock the doors.
Factory Alarm Disarmpink to black-driver kick or Body ECU, white 26 pin plug, pin 10
Meter this wire while turning the key in the driver door key cylinder. This wire will also unlock the doors with a double pulse. The Body ECU is attached to the fuse box, under the driver side dash.
Cris
albertatech 
Member - Posts: 36
Member spacespace
Joined: May 01, 2007
Location: Alberta, Canada
Posted: October 15, 2008 at 4:30 PM / IP Logged  

Not my topic but kudos anyway, was trying to do a Viper 5701 in one of these without any more info than ignition, acc, starter wires. Didnt even have my bitwriter updated for that module and had to program with the button and light. Managed to get everything else, fairly standard that. Didnt feel too good about shirting out something so when I realized locks werent what I expected I had to back off a bit.

Again, thanks. 08 toyota sequoia, remote starter -- posted image.

RANT: You know what else is helpful? The customer trying to sit in the driver seat while you are working.

albertatech 
Member - Posts: 36
Member spacespace
Joined: May 01, 2007
Location: Alberta, Canada
Posted: October 15, 2008 at 4:41 PM / IP Logged  

How are the door pins connected?

Preferably I would like to connect to them all at one place so I dont have to run to each door separately. I imagine they are probably close to the lock wires but Im not sure which.

P.S. - I am unsure if Bubba is done his unit, probably, but this seemed the place to add my question, to keep it all together.

Mike M2 
Platinum - Posts: 2,652
Platinum spacespace
Joined: June 29, 2005
Location: United States
Posted: October 15, 2008 at 6:05 PM / IP Logged  

You can use the gray keysense wire to disarm without unlocking the doors.

For door trigger, go to the light on the key cylinder. It will do all doors...

Mike M2
Tech Manager
CS Dealer Services
bubba-b 
Member - Posts: 3
Member spacespace
Joined: September 24, 2008
Location: Ontario, Canada
Posted: October 16, 2008 at 9:04 PM / IP Logged  
when refering to factory arm as lt blue to purple, what does that mean...i have looked in drvs kick and can not find arm or disarm any help is much appreciated
Dazed and confuzalized
StealthEs 
Copper - Posts: 326
Copper spacespace
Joined: September 04, 2003
Location: New Jersey, United States
Posted: October 16, 2008 at 9:26 PM / IP Logged  
it will be one color on one side of the plug and another on the other.
white 66 pin plug, pin 5, find that plug at the fuse box or go looking in the drivers kick panel and your set.
Cris

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Monday, September 26, 2022 • Copyright © 1999-2022 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer