sir pnr2 receiver

Home / the12volt's Install Bay / Car Audio / sir pnr2 receiver (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

daburrrninator

Member - Posts: 31

Joined: September 17, 2008

Posted: October 30, 2008 at 11:10 PM / IP Logged

I just got a SIR-PNR2 that I'll be installing, just not certain if this is a good way to power it or not. The instructions say to wire it to 12v, I'm assuming a switched 12v source, am I right? I was thinking of wiring it directly to the 12v power source of the HU. The connector it comes with is already factory fused with a 1A fuse. Would this be a good or bad idea? I really dont want to go straight to the battery and I dont want to cut any factory wires.

Back to Top

Search for other posts by daburrrninator

megaman

Copper - Posts: 385

Joined: June 24, 2008

Location: Montana, United States

Posted: October 31, 2008 at 8:32 AM / IP Logged

You will need a 12 volt constant. Yellow at your new HU harness.

Back to Top

daburrrninator

Member - Posts: 31

Joined: September 17, 2008

Posted: October 31, 2008 at 10:06 AM / IP Logged

Thats good, I was hoping I'd be able to splice into the harness, it will make things so much easier.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

sir pnr2 receiver

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.