2008 toyota highlander, autostart

Home / the12volt's Install Bay / Car Security and Convenience / 2008 toyota highlander, autostart (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

rhodess

Member - Posts: 10

Joined: November 03, 2008

Location: Ontario, Canada

Posted: December 01, 2008 at 10:57 PM / IP Logged

Just following on from my previous post, the keysense sits at 10.4V, when the key is inserted it drops down to about 0.5V. When I measure the keysense without the key, the fortin unit does not drop the voltage below 9.16V, so it looks like the fortin unit is the problem. I'm debating diode 'OR'ing the keysense wire to the ground out wire as well as the fortin unit to see whether the fortin unit is not getting good data on the Rx Tx lines and therfore not pulling the keysense low.

Does anyone have any other suggestions?

Thanks guys

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2008 toyota highlander, autostart

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.