clifford avant4 install help

Home / the12volt's Install Bay / Car Security and Convenience / clifford avant4 install help (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Tbonespitin

Member - Posts: 5

Joined: February 18, 2003

Location: United States

Posted: March 14, 2003 at 7:32 PM / IP Logged

Im going to start installing the alarm tomorrow and i have a couple of questions right off the bat. This is probably just the first of many so I would like to thank everyone in advance for there help. My problem is his: when wiring up the intellistart 4 unit I see i need 6 wires (plus the 2 battery leads) they are the ignition, starter, accessory, heater/ac, heater2, ignition2. with a note on heater2 and ignition2 "as required" Now this is going on a 97 chevy full-size pickup. according to my wiring diagram i have these wires available. starter(brown) iginition(pink) ignition2(white) ignition3(brown) and accessory(orange). well that leaves me with the predicament of which wires to connect to what. More specifically what do i connect the following alarm leads to? heater/ac, heater2 and ignition 2. Ignition2 is easy i'll just connect that to the second ignition wire on the truck its the heater/ac and heater2 wires on the alarm that has me at a loss. I hope that was a decent description of my problem. once again thanks for the help,

Taylor

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: March 15, 2003 at 5:46 AM / IP Logged

I have listed the wires that you need to tab into below. Just take the wires from the Intellistart4 and wire to the appropriate wires from the diagram below.

| 12V|red |+ |ignition harness |

Notes:

*1 The pink/white does not exist on all models. *2 5 wire (type C) on the two door models, and positive trigger (type A) on the four door and keyless entry models. *3 Tach wire on the 6.5 Diesel is white at the instrument cluster. Diesel wait to start wire is dk. blue (-) located at the instrument cluster 'see directfax document #1090'. *4 ECM located on drivers side inner fender well. Two plugs, white wire in plug marked 'white'. *5 Make sure to enable second ignition wires for remote starts to prevent possible transmission damage and the check engine light from coming on.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

clifford avant4 install help

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.