99 jeep cherokee xj keyless entry

01sesedan wrote: Just tested it but I put the negative lead to ground and the positive to each wire. Pink/violet shows 12.40 When I push the button, it goes to 00.00 (Unlocks) ORANGE / violet shows 2.40 Does not lock. When I push the button it goes to 00.00. For some reason this doesn't seem correct. I would think it should display the same but not sure. I'll try it the way you suggested. Thanks..

is that the only wire that color in that location? could you have tied into the wrong wire?

Yes, those are the only wires in the locations. The unlock is working but not the lock. Guess I'll have to go through each one, might get lucky. If I swap the wires, it unlocks when I arm the system. Hope to narrow it down before going nuts....

The system is a K-9 Mundial SS. Here is the manual. Page 14 shows the wiring diagram. Install Manual I'm using the Blue -trigger and Green -door input. Too bad they could not label it Lock, Unlock. Thanks.

01sesedan wrote: If I swap the wires, it unlocks when I arm the system.

 

it sounds like you have a defective unit with a bad output. those omega k-9 units are so-so. i remember buying them for like 20.00ea for three.

Gonna get with the vendor, let's see what kind of run-around I'll get. Thanks, for the input...

01sesedan wrote: The system is a K-9 Mundial SS. Here is the manual. Page 14 shows the wiring diagram. Install Manual I'm using the Blue -trigger and Green -door input. Too bad they could not label it Lock, Unlock. Thanks.

This is your problem. you are trying to use the door trigger inputs for the lock and unlock. you need to use the lock/unlock outputs from the alarm. its in its own plug. they are smaller blue and green wires. those are the lock/unlock OUTPUTS.

I notice, I was explaining it incorrectly. It was the smaller wires that I was trying, the ones with it's own plug.

In that case, i say bad unit.

It's working now. I just disconnected all of the plugs and the jeep's battery. Waited a few minutes. Then reconnected and it started to work. Secured all the connections and closed everything up.. Good thing I don't have to go through the headache of trying to get it replaced. What is not working is the second remote. I swapped the battery and it led stays on. How hard would it be to get another remote for this alarm? Could I go to the local shop and have them program a new one? Thank you very much for you help...

most likely