2002 pontiac sunfire remote start

Just installed an Audiovox APS-57 using the FlashLogic TB2 for immobilizer on the 2.2L sedan. It won't remote start but will allow remote-start-takeover once it's running with the key in. Audiovox says there's a WHITE SECOND IGNITION wire, but I don't see one in the ignition cylinder harnesses. There are 2 reds and 1 brown in one harness, 1 pink, yellow and orange in the other. There's a thinner ~18AWG WHITE going to a 3-pin harness next to the cylinder that shows 12V in acc, run, and start positions. I connected IGN2 to that one, but still no luck. ANYONE SEEN THIS ELUSIVE WHITE SECOND IGNITION WIRE??

if it stays running when you do a pit stop takeover you have all the ignition wires correct, unless one of them is dropping out during cranking. most likely you have a bypass problem.

I had another module I flashed with the same vehicle software and still no help. I'll have to call the manufacturer tomorrow and get their opinion on it since your advice sounds right ckeeler.

Turns out the ignition connects were fine and there is no white wire. I somehow tripped the passlock system during programming. Fiddled with it the next night and it fired right up. Maybe something to do with the key cycles during daily driving? In any event it's been working since. Thanks all for your input.

ckeeler wrote:    most likely you have a bypass problem.

hmmmm.....

no problem BTW.