1/0 ga won't fit

Home / the12volt's Install Bay / Car Audio / 1/0 ga won't fit (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

elemen0hpey

Member - Posts: 8

Joined: September 24, 2008

Location: New York, United States

Posted: March 12, 2009 at 8:01 PM / IP Logged

Guys,

I bought a Kicker 1/0ga dual amp install kit and the ANL fuse holder seems like its too small to fit the 1/0 into the ends. I've heard of 4ga 1/0ga combo fuse holders but never used one before.. Should I strip off some of the outside wires on the 1/0 to make it fit? What am I doing wrong? I've already stripped the rubber insulation off and it still doesn' fit. Any ideas?

hello

i am an idiot

Platinum - Posts: 13,674

This member consistently provides reliable information

Joined: September 21, 2006

Location: Louisiana, United States

Posted: March 12, 2009 at 8:49 PM / IP Logged

Some of those fuse holders have a ring inside of the connection that needs to be removed to insert the 0 Ga. wire.

Can you post a link to the install kit so I can see the fuse holder?

j.reed

Copper - Posts: 716

Joined: January 05, 2009

Location: Arkansas, United States

Posted: March 12, 2009 at 10:24 PM / IP Logged

+1 Also if you are talking about it not fitting the amp get a D block from 0 to 4 gauge to run to the amps.

1/0 ga won't fit - Last Post -- posted image.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1/0 ga won't fit

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.