wiring a 4 ohm dvc sub

i am an idiot wrote: https://www.the12volt.com/caraudio/woofer_configurations.asp If you want to run the amp at 2 Ohms, you should have stuck with the dual 2 ohm drivers.  Your only options with the dual 4s are as follows. Option 1 (parallel/parallel) = 1 ohm load Voice coils wired in parallel, speakers wired in parallel Recommended Amplifier: Stable at 1 ohm mono   Option 2 (series/parallel) = 4 ohm load Voice coils wired in series, speakers wired in parallel Recommended Amplifier: Stable at 4, 2, or 1 ohm mono

That works, man, thanks!  Oh, my previous subs were single voice coil 4-ohm not 2-ohm.  So, your diagram is exactly what I needed to know! So, I only use ONE pair of connections, right? ONE positive and ONE negative?  Cool.  I suppose if there wasn't so much info on this site I could have found this chart, but I'm relying on experts like you to help me now and then, and help me is what you did.  I was leaning more toward the Series/Parallel setup due to keeping the amps load a little less strained, but will decide at the last minute.

THANKS AGAIN! You rock!

Perfect! This will work! Just what I needed to know!  Thanks for the help.

Shawn