LED status doesn’t reset

please help! i have a clifford matrix rs2 alarm. when the alarm is triggered, my LED status indicator doesn't reset itself when i start my car.

primary harness

• orange - starter kill relay
• white - vehicle parking light
• WHITE/ blue - (-)rplemote start momentary switch [i did not hook this up]
• BLACK/ white - domelight supervision [i did not hook this up]
• green - (-) door switch wire
• blue - optional sensor, i used this for my hatch
• viloet - (+) door witch wire [i did not hook this up]
• black - ground
• brown - siren
• red - constant power
• RED / white - vehicle trunk release wire [i did not hook this up]

am i missing a connection somewhere? thanks in advance

i see! i have noticed that connection reading up on the introduction section of the car security on this site.

what if there is no wire on the primary harness for this? how would i go about and doing it? would it be possible that that hook-up is on another harness?