remote start, 2003 toyota sienna

Hey also does anyone know what anti theft system is used in the sienna. Is it a transponder or passlock. Im gettign ready to install tis rmeote start within a few days.

Read this, and you'll have your answer. Hint: Your Sienna is not made by GM.C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two

 Lets say like i have 2 starter wires And my alarm does not have extra wires to trigger a relay. WOuld i use that stater wire from remote start as the starter wire and a trigger for relay. Thanks very much for your help. HEy is starter disbale also act like anti grind.

i have a command start CS3501 and i can,tfind any installation instructions. could somebody pleasa help

kuljot, You're getting a little mixed up about "factory alarm" and "factory immobilizer." Alarm: flashes lights and honks horn when someone breaks in to steal your stuff. Immobilizer: doesn't allow car's engine to be started without a valid key. You might not have either.......what trimline of Sienna is this? CE, LE, XLE? With engine off and key removed from ignition, is there a flashing light that says "SECURITY" anywhere on the dash?

Ok thanks for your help so far. Now i have question about the tach wire. So the tech sheet says get it form ignition coil. My question is are the ignition coils the little spark plug looking things. If not can you post pictures and stuff to tell me where they are located. Thanks so much.

If you answer my last two questions, I will answer your new ones.

Ok it does not say security any where on  the dash. And i tested by opening door with key so no alarm. And i am not sure about the trimline because this is actuallyt my cousins car. But it is a min i van. i do need help with the tach question.

Kuljot               i thought you were going to give me thewiring schematic for the CS350i   I was going to  hook it up on my 1992 chev k1500 for the wife. just to make these cold mornings in newfoundland a little easier for her. Hope i am not being pushy.