noob, wiring into ignition, 1993 explorer

Home / the12volt's Install Bay / General Discussion / noob, wiring into ignition, 1993 explorer (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

swaintan

Member - Posts: 1

Joined: November 24, 2009

Location: Ontario, United States

Posted: November 24, 2009 at 3:36 PM / IP Logged

I have 1993 Ford Explorer XLT, bought a temp gauge, it says to wire it into the Cars Ignition because it is a Digital Gauge. How do I go about doing this? Never had to wire into ignition.

~*SwaintaN*~

Back to Top

ckeeler

Gold - Posts: 1,461

Joined: June 20, 2008

Location: New Mexico, United States

Posted: November 24, 2009 at 4:14 PM / IP Logged

tie into the RED / green wire in the ignition wire harness. it should show 12v when the ignition switch is turned on. test to verify.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

noob, wiring into ignition, 1993 explorer

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.