the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

remote start problem w/ viper 791xv


Post ReplyPost New Topic
< Prev Topic Next Topic >
t&t tech 
Platinum - Posts: 2,608
Platinum spacespace
Joined: October 05, 2008
Location: Trinidad and Tobago
Posted: December 06, 2009 at 7:34 PM / IP Logged  

From his original post, it clearly rules out bypass! Because he states the car starts and runs for fifteen to twenty seconds, however he states that the key light iluminates on the dash! These are conflicting circumstances! Here's something, when the vehicle dies after remote starting, with the ignition off press and hold the valet button, turn the ignition on and then back off while holding the valet switch, then release the valet switch, thenpress and release the valet switch agan, the led will report the last shutdown!

Led flashes                                shutdown mode

one                                                  timed out

two                                                  over rev protection

three                                                low or no rpm

four                                                  transmitter shutdown

six                                                    hood switch shutdown or brake shutdown

seven                                               neutral safety shutdown

eight                                                   wait to start timed out!

commit your way to jehovah and he will act in your behalf. psalms 37:5
dcash18 
Member - Posts: 38
Member spacespace
Joined: November 22, 2002
Location: United States
Posted: December 10, 2009 at 11:42 AM / IP Logged  
T&T Tech - The LED blinked 7 times. It is a posibility that the neutral safety switch (toggle switch) is defective. I will cut it out tonight and wire the BLACK/ white directly to ground. Hopefully this will fix the problem!
dcash18 
Member - Posts: 38
Member spacespace
Joined: November 22, 2002
Location: United States
Posted: December 10, 2009 at 11:52 AM / IP Logged  
I couldn't wait for tonight. Cut the BLACK/ white loose and tied it to ground. All problems solved. I can't believe a defective toggle switch was the problem all along. Thank you so much T&T Tech for the advice!
Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Wednesday, May 1, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer