200 ma enough?

Home / the12volt's Install Bay / Car Security and Convenience / 200 ma enough? (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

chriswallace187

Gold - Posts: 1,661

Joined: March 11, 2002

Location: Pennsylvania, United States

Posted: December 29, 2009 at 7:24 PM / IP Logged

No, the stray current's going from the alarm to the BCM, where it activates the trunk release circuit. Most likely that's just the wire from the release switch on the door/dash or wherever, and the BCM looks for any ground signal whatsoever.

C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two

Back to Top

Search for other posts by chriswallace187

hum dinger

Member - Posts: 26

Joined: September 28, 2008

Location: Washington, United States

Posted: December 29, 2009 at 8:07 PM / IP Logged

Thanks for the suggestions guys. Wired it like you suggested Chris, it was easier than the other suggestion so I thought I would try it first and it worked perfect. I'm sure the other way would have worked also, just a more work.

Thanks

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

200 ma enough?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.