2004 chevy impala alarm?

ok gotcha, the only thing to be ignored is the spade terminals, because i do have the remote start connected to the ignition 2 (green) wire

hey all. i just installed a galaxy 5000rs system into a chevy imapla and i wired something wrong, i been out of practice and tried to do an install and it became a disaster, if anyone could please tell me wire for wire what to connect on this vehicle so that i may go back and trace my mistakes (sigh) also i did install the passlock and it works great if anyone was wondering this links to the system and car wiring are below. thanks in advance Galaky 5000RS (scytek) wiring diagram things not working - remote start -parking lights wont flash (even though a added a relay) - trunk wont pop (i added a relay for this also)

6pin starter harness both red's connect to red @ ignition harness brown connect to dark green @ ignition harness yellow connect to pink @ ignition harness violet connect to yellow @ ignition harness 20 pin harness GREEN / WHITE connect to white @ brake pedal switch BLACK/ gray connect to white @ ignition coil yellow connect to pink @ ignition harness black connect to ground red connect to red @ ignition harness green diode isolate and connect to darkblue & darkblue/white @ bcm violet/white connect to light green @ bcm brown connect to 12v siren wire gray connect to pin 85 on relay. pin 86 & 87 connect to ground, and       pin 30 to black wire @ bcm white (make sure jumper is set to (-)) connect to blue @ parking light switch (no need for a relay according to audiovox) WHITE/ black connect to RED / black @ dkp 3 pin doorlock harness blue connect to ORANGE / black @ bcm green connect to ORANGE / black @ bcm through a 500ohm resistor And then just wire up your passlock 2 bypass.

i cant thank you enough, do i need to take out the relays i used for the trunk and parking lights or leave them in? once again thank you so much!

never mind i see you put that in there as well, i don't know where i went wrong, the parking lights just don't flash, ill take out the relay that i added, i installed it with out one the first time and it didn't work. fingers crossed, there isn't a chip in the key is there?

ok two questions what is the dkp "WHITE/ black connect to RED / black @ dkp" and secondly installed a pass2 system and it works great, do i need to add a hidden key near the ignition to allow remote starting without the key in the ignition? and i thought the same thing for the trunk, ill take that relay out as well

what is a pass2 system? and dkp = driver kick panel.

PASS2 is a unit made by omega to bypass the PASSLOCK on the car by inserting the correct ohms needed to crank the car while trying to remote start

my fault, I'm not familiar with omega products, but in that case blue/orange from the scytek must be connected to the corresponding wire on the pass2 to tell it when to turn on.