new dome lights with new switch wiring

k thanks but is the switch that is connected to the led's on the right side slot (1) tap's into the 12v + that goes to the dome light?

Ah - you mean at the top? Anywhere. +12V is +12V.

so the switch for the led switch their would be a + the + from the dome 12v and the- to the car metal right?

Que? Which part of any switch is connected to +12V? Or re-explain what you are asking..... The diagram should tell you all you need to know about the electrical connections. How it relates to physical reality is a different issue. And it will certainly be different if you had +12V switches involved!!

k if you look at you diagram on the right side of you picture with the led's their is the 3 way switch their their is the (1) with a wire going to the OX drawing on the left do i tap into that wire? also by doing this do would i need to buy the diodes in order for this to work?...

also would i need the diodes in between each led's or i would just need one in n out?

The LEDs are the diodes. Remember those lighting rods from page 1? You tap into the wires as shown on the diagram. Do not tap into your left hand indicator because that is not shown on the diagram.    Do do tap the GND to the +12V because not only is that not shown on the diagram, but is highly unrecommended by many on this forum. Also if a switch is connected between +12V and GND, I strongly advise having the O & X somewhere in between (we call X&O a "light bulb" or "lamp"; O&X is the same connected back to front) and/else the LEDs if you prefer (ie - a 12V LED string etc). Hopefully you understand the above principles. BTW - call it a hunch, but are you having difficulty understanding wiring diagrams? Or is it just the way I draw mine? Maybe instead you can post the drawing that describes your present dome light & LED wiring? I could then modify that.

i kinda understand it it just that your not understand what i am telling you...but i do appreciate your help the led(s) switch (1) is that a negative wire that is going to be tapped into the dome 12V wire? also for all the led(s) wire(s) the (4) positive can i twiste them all up and run one wire to the car battery and all 4 of the led(s) negative wires will be twisted up and run one wire to the led(s) (2)switch terminal ..... is this all right?.......i'll try an c if i can post a picture for you asap

It's only your questions I don't understand - I do understand what your are telling me.    Post the drawing.

hey oldspark im working on the picture i was just wondering if i am adding 4 led(s)..would i need to put a fuse in between to 12V source and the led(s)...if so would you happen to know how much amp fuse would i need?