2010 tundra reverse wire, xk05 programming

Ok 2 quick questions. 1. Where can I find the reverse wire on a 2010 toyota tundra double cab? 2. I bought the XK05 bypass and was told 2 keys are required however the instructions dont mention the second key. They basically say wire it, connect it, turn the key to ign and the red light on the bypass turns solid, start truck with key, the solid red light goes out and the bypass is programmed. Where do you use the second key?

It's a blue wire in the passenger kick panel.

Don't know the XK, but i have never seen a bypass in a Toyota need two keys....

Mike M2

Tech Manager

CS Dealer Services

What firmware is loaded on the XK05? 

 I have used and prefer the 5.PKTI firmware ( over the PKT2 firmware ) on earlier Tundra's.  It is an easier install and works great.  Either way you should need only one working key.

Soldering is fun!

I prefer the PKALL over the XK05...Big Al

i don't know about you guys but i had a problem with a 09 tacoma when programing the module would not program i though i was doing something wrong i try a differente module same thing then i call tech support and they told that that some toyotas you have to try different keys if it does not work i did this and it work but only happened once but to program you only need one key if the first does not work try a second key hope it helps

You cannot use the gray valet key....Mike M2

Tech Manager

CS Dealer Services