prestige 997n into honda del sol

This is going to be my second alarm install. The other alarm was more straight forward however the 997n is a bit confusing

It dosent have a ign starter/key side. 

it list. Ign1, Ign2, Bat1, Bat2 can someone explain how this would work..  heres the cars pinout

Heres exactly whats under the main 6pin power harness

Acc, IGN1 ,Bat2, Bat1, Start, IGN2, IGN3

I know what goes where elsewhere on the brain just cant figgure out how to wire this to the ignition harness

Put the 2 red bat wires together to the white constant 12v.

start yellow to starter.

Ign1 blue to Ign.

Ign2 green to Ign2.

Ign3(should be violet) isn't an Ign but an accessory. connect to(you guessed) accessory...

< color=#0000cc>Ok that cleared things alot more. Thanks for your help!!

As far as a starter kill/< color=#0000cc>Interrupt how would i go about this? the relay that came with the alarm is wired as "Normally Closed" diode between 86-85

would it go like this?  post (86) tap to the two red wires at constant 12v, Post (85) to alarm - out when disarmed, Post (87a) to starter (Ignition Switch Side), Post(30) to starter (Starter Side)?

Anyhelp is well appreciated..  I may seem noobish but i know my way around wiring mainly ( engine harness's, radios, windows,seats) not knowing much about alarms from the getgo dont help. Besides my heads in the clouds with a Death in the family then tackling a project to find out the dude that owned the car before me rigged EVERYTHING to do with wiring!! 

Again Thanks for the help..

< color=#0000cc> 

Almost forgot the alarm is going on a manual car so i wont be needing the R/S feature

Will i still need Ign1,Ign2 acc and Start? or can i get away only using the bat1 and bat2 wires?

Ok you do not want to connect post 86 to constant. That will create a current draw when the car is sitting in your driveway. Instead, connect post 86 to the Ign1 wire so the relay can't work until the ignition is on. Post 85 to the orange GWA wire on your alarm, the other 2 posts fine.

If you are not using the RS, all you need to connect is the 2 reds constants and the blue Ign1. You don't need the Ign2, Acc, or start wires...

Just dropping by, that system is a real pain to install, don't get me wrong it isn't hard per say, but the system was designed so untidily, it's just no fun to install at all.

Sorry for being late and all, ive been very busy with the funeral but thank you guys so much!!

I worked all the bugs out. i just need a new door switch one door isnt working with the alarm.